Description
SPEEDY CARBONIUM ANTIFOULING
TWO-COMPONENT ANTIFOULING FOR RACING BOATS
SMOOTH LOW DRAG COATING
HIGH ANTIFOULING PERFORMANCE
QUICK DRYING
TWO-COMPONENT
SUITABLE FOR LIGHT ALLOY
CHARACTERISTICS
TECHNICAL DATA
Curing mechanism: solvent evaporation
Specific weight: 1,00 ± 0.02 kg/lt
Volume solids: 53 %
Flash point: +25°C
Aspect: matt
Unit size: 0,75 Lt
Colour: grey
SURFACE PREPARATION
This antifouling is applied over itself, on new or stripped surfaces. To make best use of the low drag feature of this paint, it is strongly advised not to apply on old antifouling even if recoated with sealer.
On new new surfaces: clean and/or degrease well and apply a coat of Adherglass or Adherpox.
On Speedy Carbonium: high press clean, restore defects and allow to dry well.
APPLICATION PROCEDURES
Stir the components separately for a few minutes until completely homogeneous. Add component B to component A and mix thoroughly in the proportion indicated.
For best performance it is necessary:
a) let the mixture stand for about an hour;
b) apply the product by spraying (thinning 5-10% with Thinner 6470). Two coats with minimum drying interval of 6 hours (at 20°C). An extra coat is recommend on boot top and on rudder;
c) 24 hours after application of the last coat, wet-sand with 600 grit abrasive paper until a completely smooth surface has been achieved.
APPLICATION
Drying time before use (20°C): min 8 hrs
Pot life (20°C): 48 hrs
Application temperature min/max: +5/+35°C
Hardener: 6432.999
Mixing ratio by volume: 2:1
Mixing ratio by weight: 67:33
Thinner: 6470
Wet film thickness per coat: 100 µ
Dry film thickness per coat: 50 µ
Theoretical coverage per coat: 10,6 m2/lt
Recoating time at 20°c min 4 hrs
Number of coats: 2
Spray application data
Conventional Airless
Nozzle diameter 1.4 / 1.6 mm 0.018 / 0.021
Air pressure: 3.0 / 3.5 bar100 / 120 bar / nozzle
Compression ratio: 30 : 1